JamKazam Forums   ›   Jamkazam Forums   ›   Help with Audio Gear   ›   Bose ToneMatch T1 and ASIO4ALL

  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Bose ToneMatch T1 and ASIO4ALL
markoyonas
Junior Member
**
Joined: Apr 2020
Posts: 2

Reputation: 0
#1
04-28-2020, 06:00 PM (This post was last modified: 04-28-2020, 09:19 PM by markoyonas.)
I have had some success using a Bose ToneMatch T1 board with JamKazam using the ASIO4ALL driver.  A diagram is attached with my particular setup.  I upgraded to version 3.14 of the ASIO4ALL driver and found that I could never get my gear latency below 15ms for a session, even though the JamKazam gear setup and loopback test showed 3.15 ms of latency for the gear.  So I deleted the latest version of ASIO4ALL and went back to the previous 2.13 version - which worked!


Attached Files
.pdf   BOSE T1 Interface diagram for JamKazam.pdf (Size: 91.78 KB / Downloads: 9)
  Reply
marhdeth
Member
***
Joined: Apr 2020
Posts: 69

Reputation: 7
#2
04-28-2020, 06:48 PM
Nice diagram!
  Reply
kempjef
Member
***
Joined: Apr 2020
Posts: 52

Reputation: 2
#3
04-28-2020, 07:25 PM
I use a 2nd gen Focusrite 6i6. I found the beta Focusrite software to be of no help. I uninstalled, then reinstalled the production version. I set it to 96000/64, and JamKazam stopped trying to change it at those settings. I got latency of 3.92 ms in the Audio Gear setup of JK, and I'm able to use the 1ms frame rate without any problems. Also: I know this seems strange, but USB 3.0 was necessary--when using USB 2.0, the signal was noisy and unusable. Good luck!
  Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)