+- JamKazam Forums (https://forum.jamkazam.com)
+-- Forum: Jamkazam Forums (https://forum.jamkazam.com/forumdisplay.php?fid=1)
+--- Forum: Help with Audio Gear (https://forum.jamkazam.com/forumdisplay.php?fid=4)
+--- Thread: Bose ToneMatch T1 and ASIO4ALL (/showthread.php?tid=621)
Bose ToneMatch T1 and ASIO4ALL - markoyonas - 04-28-2020
I have had some success using a Bose ToneMatch T1 board with JamKazam using the ASIO4ALL driver. A diagram is attached with my particular setup. I upgraded to version 3.14 of the ASIO4ALL driver and found that I could never get my gear latency below 15ms for a session, even though the JamKazam gear setup and loopback test showed 3.15 ms of latency for the gear. So I deleted the latest version of ASIO4ALL and went back to the previous 2.13 version - which worked!
RE: Bose ToneMatch T1 and ASIO4ALL - marhdeth - 04-28-2020
Nice diagram!
RE: Bose ToneMatch T1 and ASIO4ALL - kempjef - 04-28-2020
I use a 2nd gen Focusrite 6i6. I found the beta Focusrite software to be of no help. I uninstalled, then reinstalled the production version. I set it to 96000/64, and JamKazam stopped trying to change it at those settings. I got latency of 3.92 ms in the Audio Gear setup of JK, and I'm able to use the 1ms frame rate without any problems. Also: I know this seems strange, but USB 3.0 was necessary--when using USB 2.0, the signal was noisy and unusable. Good luck!