output channel assignment error

[StuartR]

When I change to 9 & 10, I get an error saying I have 4 outputs defined, and I can only have 2. So, in order to get past this error, I change back to 1 & 2, but I still get the error saying I have 4 outputs. That's when I have to restart JK.

This is the sequence with screen grabs attached:

1. In configure tracks, click update outputs
2. In session audio output, change channel 1 to channel 9; channel 2 to channel 10
3. Click update ports. At this point, the error about 4 ports pops up.
4. Click close on error.
5. Click update outputs.
6. Change channel 9 to channel 1; channel 10 to channel 2.
7. Click update ports. The error about 4 ports comes up.

At this point I'm stuck. I can't get out of this sequence without quitting JK. I don't see a way to delete ports. I can only change. but somehow 2 ports were added.

>>>
Like I said, delete the profile and add it again, takes little time/effort ... . And you're playing again.

Yes, that worked. Though I still think it ought to be fixed. My expectations are much higher now that I’m paying for my whole band’s subscriptions.

Please forward this issue to: support@Jamkazam.com

yes, I’ve done that. Is there a way to check on it?

Are you at a subscription level that has helpdesk support?