Focusrite Scarlett Solo 3rd Gen

[lucabat]

Hello,

I am trying to get a Focusrite Scarlett Solo (3rd Gen) working on Windows 10.

JamKazam software is recognizing the device and I chose ASIO but I can't get Latency (80.91) and I/O Rate out of the red.

It's one of the best selling devices, so I was hoping that somebody here can help me to get it up and running.

I am not using WiFi but a cable with a USB-to-Ethernet adapter (86Mbps down, 37Mbps up).

Thank you!

Anton

Hi Anton, trying to go on the setup of the Focursite Scarlett and set the bitrate to 96Kbps and the buffer as small as possible (or smaller than the usually 128bit).

With this configuration Jamkazam test should be about 10/12 ms of latency!

Ciao
Lucabat