04-06-2020, 10:59 PM
Hi schristen,
So i am getting the port changes messages as well. I have not been able to do verification yet. I was under the impression that i needed to do verification BEFFORE i could do a session. Is that assumption wrong?
I am ignorant about the usage of port numbers UDP/TCP 12000-12010 by Jamkazam. Where is that documented? And where do you set that in JamKazam?And you can guess by my questions, that i am NOT doing any port forwarding of the those ports at this time. Ok. i see that the ports are set in Preferences. Got it. Will try that and get back to you later... i can't do test at this moment. Thanks so much for giving me the lead.
I do have "Enable NAT Port Mapping Protocol" (referred to as NATPNP by someone earlier in this thread) checked on. That is in "Network Options" shade, from click the same named button at the bottom of Network tab in AU.
Peace,
Dan
So i am getting the port changes messages as well. I have not been able to do verification yet. I was under the impression that i needed to do verification BEFFORE i could do a session. Is that assumption wrong?
I am ignorant about the usage of port numbers UDP/TCP 12000-12010 by Jamkazam. Where is that documented? And where do you set that in JamKazam?And you can guess by my questions, that i am NOT doing any port forwarding of the those ports at this time. Ok. i see that the ports are set in Preferences. Got it. Will try that and get back to you later... i can't do test at this moment. Thanks so much for giving me the lead.
I do have "Enable NAT Port Mapping Protocol" (referred to as NATPNP by someone earlier in this thread) checked on. That is in "Network Options" shade, from click the same named button at the bottom of Network tab in AU.
Peace,
Dan