• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Edirol/Roland UA-101 ASIO higher latency than WDM
#7
(03-12-2021, 05:01 PM)StuartR Wrote:
(03-11-2021, 02:05 PM)frednat Wrote:
(03-11-2021, 01:08 PM)StuartR Wrote:
(03-05-2021, 12:22 PM)frednat Wrote: Hi, I didn't get much replies, but in case someone reads this further down the line, I managed to make it work - barely:

-I lowered the audio buffer size to the minimum (1), and clicking "Use Smaller ASIO Buffer Size" in the UA-101 driver settings
-I set frame size at 1 in Jamkazam

I then get an ok-ish 16ms latency which puts me in the orange category. Still not perfect. But workeable.
I believe the UA-101 is a discontinued product which won't have an optimized driver. Did you look at the JK recommended audio interface list?
Thanks for the reply. I'm in the middle of getting a new one. I'm hesitating between the MOTU M2 and the Presonus 24c/26c. I'm hearing people are very happy with the 24c and latencies were super low (4ms). The MOTU M2 has better audio qualities, however some of the tests by Julian Krause showed that latency was a bit higher. MOTU M2 are also very hard to find!
I can vouch for the MOTU M2. We used several of these. The only caveat is that if you're using them on MAC systems you'll need to load their Thunderbolt driver and that's means your MAC has to have those ports. Otherwise the latency won't be as good as it could be.
Thanks Stuart, I'm setting it the MOTU as I type!

The main problem with the UA-101 is even though there is a Win 10 driver, the lowest number of samples is 112 (vs 16 for the MOTU M2, or even 4 for the Tascam 102i!).  I think that's where my latency comes from. Ideally I'd be able to hack the driver and for the number of samples lower.
  Reply


Messages In This Thread
RE: Edirol/Roland UA-101 ASIO higher latency than WDM - by frednat - 03-12-2021, 06:36 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)