Behringer Xenyth 302USB - make it work?

[Sizzelicks]

Hi:


As titled, I"ve got a Behringer Xenyth 302USB:
https://www.behringer.com/Categories/Beh...ans(en|en)

It works in Windows and other apps just fine.
I'm using stock Windows drivers for it
JamKazam sees (in the dropdown) drivers for:
Microphone (USB Audio Code)  - WDM
Speakers (USB Audio Code)  - WDM
Those are the drivers the Behringer is using and again, they work fine outside JamKazam.

"It appears this audio device is not currently connected. Attach the device to your computer and restart the application, or select a different device."

I tried changing the sample rate to all possible.
I tried AISO 4 All: Latency problems + nasty feedback that I couldn't control.

Nothing works.

[allhookedup]

Hi:


As titled, I"ve got a Behringer Xenyth 302USB:
https://www.behringer.com/Categories/Beh...ans(en|en)

It works in Windows and other apps just fine.
I'm using stock Windows drivers for it
JamKazam sees (in the dropdown) drivers for:
Microphone (USB Audio Code)  - WDM
Speakers (USB Audio Code)  - WDM
Those are the drivers the Behringer is using and again, they work fine outside JamKazam.

"It appears this audio device is not currently connected. Attach the device to your computer and restart the application, or select a different device."

I tried changing the sample rate to all possible.
I tried AISO 4 All: Latency problems + nasty feedback that I couldn't control.

Nothing works.

I've also received this message intermittently, I had to power cycle my interface and restart the Jamkazam app to get it to recognize the device again. Try that.

[Sizzelicks]

I found this out - here.
Windows was comandeering the drivers so JamKazam couldn't use them.
I reset the Windows sound drivers to the hardware on the mother board.
That left my USB mixer available for another app to use.
I set the Behringer drivers to JamKazam.

I was able to get the drivers to work in JamKazam with no problem.
Thanks.