Network test failed

[jcmartin3@rocketmail.com]

I've set up the network as suggested, making sure UDP ports 12000-12010 (overkill, I know) are not changed, and are allowed back in and forwarded to the correct computer.  I grabbed a packet capture of a network test when I was finally able to run one. I saw no packets going out using this UDP port range. I did, however, see STUN traffic, so I did the same with the standard STUN UDP port, reran the test, and it still failed.  I see STUN traffic going to one server (74.125.192.127) and I'm getting replies. I then see it change to another server (63.114.108.101) and I'm getting ICMP port unreachable messages back from it. It continues to send STUN binding requests to both addresses, still getting binding responses from the first and ICMP port unreachable messages from the second. It then switches to sending TCP traffic to 45.79.61.39, first on port 6767 then on 80 (http). At that point the test ends and I get the failure message.  If you need me to send a copy of the Wireshark packet capture, send me an email and I can forward it along.

Thanks,
John

Well known and much discussed issue (use the search)
Just proceed, it'll be fine. (unless your values are way-off, than you cannot)

I did this because it wasn't working and I wanted to know why. Maybe I need to just get into a session with Wireshark running and see what happens. But I find it odd that the network test doesn't use the same UDP ports that are required for the sessions.