11-03-2020, 01:35 AM
(11-02-2020, 11:49 PM)livnik Wrote:(11-02-2020, 08:03 PM)Dimitri Muskens Wrote:(11-02-2020, 06:14 PM)livnik Wrote: Hi,>>>
I have a problem with my new Win 10 and sessions in Jamkazam. My audio gear (Behringer UMC 202) works very well on my laptop HP Win 8 64-bit but with my desktop PC, having recently installed Win 10, there is a big trouble for me.
For instance, I've hardly managed to set my audio gear, and when I try to open a new session my audio gear works about 5-10 sec then disappears, becomes gray on Jamkazam, and on UMC Control Panel appears ASIO not active, but initially has appeared ASIO is active for about 5-10 sec. If I unplug the USB of UMC202 and start Resync it works again about 10 sec then disappears again, then appears an Alert saying INVALID AUDIO DEVICE. I cannot understand what it happens.
- I have installed ASIO4ALL v.2.14 and UMC drivers 4.59.0.
- CPU i3 3.7GHz (9th generation), MB ASUS H310M-E, 8gb RAM, GPU Palit nVidia GeForce GT630 etc.
Could anyone help me...
Completely(!) remove asio4all. Reboot and make sure it's gone
Use the Behringer dedicated ASIO driver only (4.59)
Make sure you use the Behringer (ASIO) in the Jamkazam gear setup for both input & output device.
>>>
It works but I can't hear stereo on my headphones as before, and it doesn't install ASIO from Behringer...
>>>
You'll have to choose the correct ASIO driver in the drop-down menus when adding your gear. (you did remove the previous config I presume?)
If you can not, the Behringer 4.59 is not properly installed on your computer.
As you can see in you screen shot you're using WDM (standard windows audio driver) not ASIO.
Also don't fill in both drop-downs when adding a channel so it will automagically centre the audio (into a stereo signal)