07-30-2020, 08:29 AM
(This post was last modified: 07-30-2020, 08:30 AM by frednat.
Edit Reason: adding information
)
Hello everyone,
I've plugged in my Edirol UA-101 interface in Jamkazam for the first time today.
I've tweaked the ASIO settings for buffer size and I'm on ultimate power settings, but I just get terrible latency numbers:
Latency: 73.86ms
I/O rate 397
Var 5.81
Latency was a whopping 350ms+ before tweaking everything.
Where it gets extremely odd is if I switch to WDM, which should be slower, I then get:
Latency: 20ms
I/O rate 100
Var 0.32
ASIO works fine with Cakewalk, I get no latency. I'm expecting latency in the low teens or even below 10ms.
I've tried it on my other (older and slower) windows 10 PC and I get the same problem.
Does anyone have the same issue? Or any pointers at to what I'm doing wrong?
Thanks for looking
Fred
I've plugged in my Edirol UA-101 interface in Jamkazam for the first time today.
I've tweaked the ASIO settings for buffer size and I'm on ultimate power settings, but I just get terrible latency numbers:
Latency: 73.86ms
I/O rate 397
Var 5.81
Latency was a whopping 350ms+ before tweaking everything.
Where it gets extremely odd is if I switch to WDM, which should be slower, I then get:
Latency: 20ms
I/O rate 100
Var 0.32
ASIO works fine with Cakewalk, I get no latency. I'm expecting latency in the low teens or even below 10ms.
I've tried it on my other (older and slower) windows 10 PC and I get the same problem.
Does anyone have the same issue? Or any pointers at to what I'm doing wrong?
Thanks for looking
Fred