07-20-2020, 12:25 AM
(07-19-2020, 12:41 AM)Lex Music Wrote: I am answering my own question here re. Zoom H4 setup...
If you're using this 'old' device here is what I have learned and have now tested with J-K:
Hope it helps and see you on my next Gypsy Jazz session!
- to get H4 connected via its ASIO and USB interface it needs to have an upgraded firmware '2.4'
- load the firmware from Zoom site, unzip and transfer it to the root directory of the SD card
- power up H4 (using AC power adapter) while pressing and holding the round 'MENU' button down
- load 'H4' ASIO driver from the Zoom site (in my case for WIN7, 64bit O/S)
- install the driver
- next, connect H4 using: MENU - USB - AUDIO I/O - CONNECT
- Windows will identify, install and hopefully give you a 'Device Installed Successfully' message
- finally, setup J-K with H4 ASIO driver (again in my case I reset Audio Properties first to start 'clean'
- it's working seeming better better and with lower latency now
Cheers, lex
Dear J-K users,
Having problems with ZOOM H4 - USB driver 'device not recognised' on WIN7
- loaded the 'H4' driver from the Zoom site
- it installs OK on 64bit WIN7 laptop
- however, when connecting the H4 I get 'USB device unrecognised' message
- I tried different USB ports on the laptop, as well as re-install the driver, restart laptop, etc.
- I also tried installing the driver in WIN7 compatibility mode with the same error
Does this happen to anyone else?
Is there a tried way to connect the H4 to J-K...?
My thanks in advance.
Lex