06-27-2020, 10:51 PM
So, on my Quad Capture, I have 4 analog inputs and 2 analog outputs. Normally I plug a mic into input 1 and my guitar cable into input 2. In Jamkazam, I run two audio tracks. On one I select input 1 and label as Voice (with use microphone option for chat). On the other audio input I select input 2 and label guitar. (I use a stereo amp sim vst also on this channel). This setup works perfectly for Jamkazam sessions, allowing for separate volume control of voice and guitar.
I also have S/PDIF coaxial input/output on the interface, to which I connect my Kemper. In Jamkazam, I delete audio input 2 (guitar) and replace it with another audio input on which I select digital channels 3-4 as the inputs. This works the first time I enter a session for about 5 seconds or so I can hear the Kemper, then it mutes, and I can't find a way to make it active again.
I also have S/PDIF coaxial input/output on the interface, to which I connect my Kemper. In Jamkazam, I delete audio input 2 (guitar) and replace it with another audio input on which I select digital channels 3-4 as the inputs. This works the first time I enter a session for about 5 seconds or so I can hear the Kemper, then it mutes, and I can't find a way to make it active again.