06-26-2020, 10:37 PM
Last night I tried using my Kemper Profiler with Jamkazam, via S/PDIF, and all I could get was maybe 5 seconds of audio from the Kemper after entering a solo session. After that, the S/PDIF audio was muted, and I could not figure out how to get it back. Are there any special settings that need to be made, to keep my S/PDIF connection active in Jamkazam, during a session?
A little additional info on my setup. I'm using a Roland Quad Capture USB interface in Windows 10. I connect my vocal microphone to input 1, and I route S/PDif from my Kemper to channels 3&4 of the Quad Capture . In Jamkazam, I have one audio input for the vocal mic (input ch1), and another audio input for guitar (ch3&4 selected).
Upon starting Jamkazam, and a new session, I can hear the Kemper via S/PDIF for about 5 seconds while the VST scan happens. Once the scan ends, the S/PDIF appears to get muted, and I can no longer hear the Kemper. Even if I leave the session and start a new one, it remains muted. If I shutdown the Jamkazam app, and reopen, It will work again for 5 seconds then the same thing happens. I'm not using any VST's on either channel of this profile BTW.
As a side note, If I open Cakewalk Bandlab, add a channel, and put that channel in record arm mode, I find that the S/PDIF from the Kemper is working perfectly. It just seems to be an issue with the Jamkazam software or configuration.
Any help would be appreciated.
A little additional info on my setup. I'm using a Roland Quad Capture USB interface in Windows 10. I connect my vocal microphone to input 1, and I route S/PDif from my Kemper to channels 3&4 of the Quad Capture . In Jamkazam, I have one audio input for the vocal mic (input ch1), and another audio input for guitar (ch3&4 selected).
Upon starting Jamkazam, and a new session, I can hear the Kemper via S/PDIF for about 5 seconds while the VST scan happens. Once the scan ends, the S/PDIF appears to get muted, and I can no longer hear the Kemper. Even if I leave the session and start a new one, it remains muted. If I shutdown the Jamkazam app, and reopen, It will work again for 5 seconds then the same thing happens. I'm not using any VST's on either channel of this profile BTW.
As a side note, If I open Cakewalk Bandlab, add a channel, and put that channel in record arm mode, I find that the S/PDIF from the Kemper is working perfectly. It just seems to be an issue with the Jamkazam software or configuration.
Any help would be appreciated.