Add Audio Track Does Nothing

[cstats]

Thanks I'll give it a shot.  I'm using a windows  machine,  but hopefully I can find the interface's sample rate.  I appreciate your response.

Scott

---

Thanks I'll give it a shot.  I'm using a windows  machine,  but hopefully I can find the interface's sample rate.  I appreciate your response.

Scott

No luck on my end - I hope your solution works for standupbassist. 

I did find the sample rate for the recording portion of my audio interface in windows under the advanced options within its properties page under control panel.  I ended up changing the sample rate of the recording portion of the interface via the windows control panel from 44.1 to 48 kHz, as Jamkazam was complaining about the speaker output sample rate being 48 kHz, while the recording side was set to 44.1 kHz.  However, in all cases, I'm still at the configure page without available tracks.

i

Scott

In my case it worked when I changed the sample rate in Jamkazam, not in my interface.