06-05-2020, 05:39 AM
Still trying to figure out to get JK to run using sound from Logic Pro X 10.5.
A few minutes ago. I signed in and tried to change the audio and out channels. I made sure the Aggregate Device and Black Hole to Output devices were set up OK and highlighted on the Mac under audio settings.
I tried to verify the channels were set up correctly, attempting to change one of the input channels. I tried to change the audio inputs from channels 1 and 2 to 3 and 4, but when as I deleted channel 1, a message popped up saying I need to identify 4 channels. It wouldn't set me change, nor set new, channels.
What do I need to do differently, please?
Also, the instrument display was blank and would not let me input the name of the instrument. I've not seen this happen before. Consequently, I was unable to continue trying to connect and attempt a test recording.
Thanks,
Nick Costa
A few minutes ago. I signed in and tried to change the audio and out channels. I made sure the Aggregate Device and Black Hole to Output devices were set up OK and highlighted on the Mac under audio settings.
I tried to verify the channels were set up correctly, attempting to change one of the input channels. I tried to change the audio inputs from channels 1 and 2 to 3 and 4, but when as I deleted channel 1, a message popped up saying I need to identify 4 channels. It wouldn't set me change, nor set new, channels.
What do I need to do differently, please?
Also, the instrument display was blank and would not let me input the name of the instrument. I've not seen this happen before. Consequently, I was unable to continue trying to connect and attempt a test recording.
Thanks,
Nick Costa