Latency Improvement?

[Jim Ford]

I am using a Scarlett 2i2 into a 2012 Macbook Air running OS 10.12 with a Thunderbolt adapter/ethernet connection.  My interface latency is 10.3ms and I cannot figure out any way to improve this.  My interface sample rate is synched at 48000 and my router download speed is 190.5mbps (this test was run on my Xfinity account page - I have, for some reason been unable to test my network speed on JKZ).  Any ideas would be appreciated!

Have you tried to lower your "Frame Size" ??  
Manage / Audio Settings / Audio Booster / Audio Framesize 1ms or 2 ms..

HTH,~JB

You have to be in a session to make the change. It will not be grayed out in a session, so just start a solo session.

Thanks for the quick reply.  When I go on Audio Boost, the Frame Size box is empty and grayed out.  The buttons "Audio Throttle Bitrate" and "Media Stream" in the Outgoing Audio Bitrate section are checked.  I tried unchecking them but the Frame Size box remained grayed out.  The Maximum Outgoing Bitrate is grayed out but shows 320kbit/s.

[Scott_Graham]

I am using a Scarlett 2i2 into a 2012 Macbook Air running OS 10.12 with a Thunderbolt adapter/ethernet connection.  My interface latency is 10.3ms and I cannot figure out any way to improve this.  My interface sample rate is synched at 48000 and my router download speed is 190.5mbps (this test was run on my Xfinity account page - I have, for some reason been unable to test my network speed on JKZ).  Any ideas would be appreciated!

Have you tried to lower your "Frame Size" ??  
Manage / Audio Settings / Audio Booster / Audio Framesize 1ms or 2 ms..

HTH,~JB

You have to be in a session to make the change. It will not be grayed out in a session, so just start a solo session.

Thanks for the quick reply.  When I go on Audio Boost, the Frame Size box is empty and grayed out.  The buttons "Audio Throttle Bitrate" and "Media Stream" in the Outgoing Audio Bitrate section are checked.  I tried unchecking them but the Frame Size box remained grayed out.  The Maximum Outgoing Bitrate is grayed out but shows 320kbit/s.

You need to be in a session to change the frame rate.  You can use a solo session.