08-26-2020, 01:21 PM
I am trying to set up a newly purchased UMC204HD.
Every time I try to launch, I get an error that my UMC204HD is not configured properly and I am taken through steps to correct this.
The automated pathway never works, and when I opt for the manual pathway it has me open the UMC Control Panel and set ASIO buffer size to 64 (which is easy), but also set USB streaming mode to 'short latency'. However, there *is* no option for setting USB streaming mode in the UMC Control Panel. I am pretty sure I have the most recent version of the Control Panel. How do I set the USB streaming mode? What am I doing wrong. The UMC204HD was highly recommended by forums, but so far it has been frustrating to work with.
Does anyone know where I am screwing up?
Any help appreciated.
-flyman
Every time I try to launch, I get an error that my UMC204HD is not configured properly and I am taken through steps to correct this.
The automated pathway never works, and when I opt for the manual pathway it has me open the UMC Control Panel and set ASIO buffer size to 64 (which is easy), but also set USB streaming mode to 'short latency'. However, there *is* no option for setting USB streaming mode in the UMC Control Panel. I am pretty sure I have the most recent version of the Control Panel. How do I set the USB streaming mode? What am I doing wrong. The UMC204HD was highly recommended by forums, but so far it has been frustrating to work with.
Does anyone know where I am screwing up?
Any help appreciated.
-flyman