06-15-2020, 02:08 PM
Hi
I was surprised to find that when I use my Zoom R 16 mixer in Audio interface mode it is rejected on set up test for high latency. OK, I am using basic equipment but I am using a wired Ethernet, and also surprisingly, the onboad laptop hardware sound input, Realtek built in mic, WAS accepted.
Zoom results below ASIO and WDM
Line (ZOOM R16_24 Audio Interface) -WDM
Result: Latency 25.67ms
Your latency is poor
ZOOM R16_24 ASIO Driver-ASIO
Result: Latency 97391544ms (No decimal places!?!? Thats about 3 hours I think)
Can anyone advise on settings?
Incidentally I have tried ways to mute my mic input as I am new and joining pages just to test and don't want to disturb the sessions by introducing exrta latency but I am not sure how to do this. In Windows sound settings I can disable the mic, and I get flahed up notifications saying that various session members are getting no audio from me, but in fact on the first session I tried the group leader on mic said that eeryone COULD hear me. Can anyone explain this?
Many thanks
Windows 10 64 bit
Dell Latitude 3470 with i3-6100U cpu
Interface:
Zoom R16 in Audio Interface mode, Windows drivers downloaded
Other on board hardware:
Jack mic Realtek WDM
Microphone array Realtek WDM
Realtek ASIO
Stereo mix WDM
I was surprised to find that when I use my Zoom R 16 mixer in Audio interface mode it is rejected on set up test for high latency. OK, I am using basic equipment but I am using a wired Ethernet, and also surprisingly, the onboad laptop hardware sound input, Realtek built in mic, WAS accepted.
Zoom results below ASIO and WDM
Line (ZOOM R16_24 Audio Interface) -WDM
Result: Latency 25.67ms
Your latency is poor
ZOOM R16_24 ASIO Driver-ASIO
Result: Latency 97391544ms (No decimal places!?!? Thats about 3 hours I think)
Can anyone advise on settings?
Incidentally I have tried ways to mute my mic input as I am new and joining pages just to test and don't want to disturb the sessions by introducing exrta latency but I am not sure how to do this. In Windows sound settings I can disable the mic, and I get flahed up notifications saying that various session members are getting no audio from me, but in fact on the first session I tried the group leader on mic said that eeryone COULD hear me. Can anyone explain this?
Many thanks
Windows 10 64 bit
Dell Latitude 3470 with i3-6100U cpu
Interface:
Zoom R16 in Audio Interface mode, Windows drivers downloaded
Other on board hardware:
Jack mic Realtek WDM
Microphone array Realtek WDM
Realtek ASIO
Stereo mix WDM