+- JamKazam Forums (https://forum.jamkazam.com)
+-- Forum: Jamkazam Forums (https://forum.jamkazam.com/forumdisplay.php?fid=1)
+--- Forum: Help with Audio Gear (https://forum.jamkazam.com/forumdisplay.php?fid=4)
+--- Thread: Latency Unknown (/showthread.php?tid=431)
Latency Unknown - Pete "Shu's" Davies - 04-17-2020
I have a Focusrite Solo 3rd Gen. running at 120/48000
I am set up and running on Jamkazam.
The query I have is when I set up Audio gear the LATENCY was grey Unknown, the I/O was yellow and I was able to continue.
Why was my latency not detected?
RE: Latency Unknown - Hans Peter Augustesen - 04-17-2020
I tried something similar with Focusrite 2i2 2. Gen(eration).
AUDIO GEAR setup annonced that the actual amount of latency could not be provided.
And that I could do a special test to determine the actual figure, which I never did.
That will say, I tried after the setup - but I am not sure if I did it right.
I could proceed - like you. And go in session and all that.
But afterwards, maybe some hours or days, the actual figure showed up: 7.2 or so milliseconds
it was one I borrowed and I no longer have it
RE: Latency Unknown - Patrice Brousseau - 04-18-2020
(04-17-2020, 10:28 AM)Pete "Shu Wrote: I have a Focusrite Solo 3rd Gen. running at 120/48000Windows or Mac? If Mac, you could try this: https://support.focusrite.com/hc/de/arti..._1.1.7.dmg
I am set up and running on Jamkazam.
The query I have is when I set up Audio gear the LATENCY was grey Unknown, the I/O was yellow and I was able to continue.
Why was my latency not detected?