04-26-2020, 11:41 AM
Just installed my new Steinberg UR22C (USB3.0) and seems fine on a solo session - testing with band this afternoon.
Need to read the instructions and download driver and tools before installing. Initial settings with buffer rate at 512 samples give high latency and I/O delay but reduce it down to say 32 or 48 and it's all green.
Need to have mic on input 1 and bass on input 2. Phantom power switched on, HI-Z button for bass input2 'on' (pushed in).
Can only hear my mic and bass thru' headset when I'm in a session or recording - not during audio setup for some reason. Maybe because I have the input/DAW dial turned all the way to DAW as advised by JK.
Can be used on USB2.0 and it's fine so USB3.0 is probably overkill unless you need the higher quality for recording. With USB2.0, instructions say you need an external power source - a separate USB charger connection. Seems to work without, but power supply solely through the USB2.0 may drop out from time to time?
Will update after band session test.
Need to read the instructions and download driver and tools before installing. Initial settings with buffer rate at 512 samples give high latency and I/O delay but reduce it down to say 32 or 48 and it's all green.
Need to have mic on input 1 and bass on input 2. Phantom power switched on, HI-Z button for bass input2 'on' (pushed in).
Can only hear my mic and bass thru' headset when I'm in a session or recording - not during audio setup for some reason. Maybe because I have the input/DAW dial turned all the way to DAW as advised by JK.
Can be used on USB2.0 and it's fine so USB3.0 is probably overkill unless you need the higher quality for recording. With USB2.0, instructions say you need an external power source - a separate USB charger connection. Seems to work without, but power supply solely through the USB2.0 may drop out from time to time?
Will update after band session test.