Just installed my new Steinberg UR22C (USB3.0) and seems fine on a solo session - testing with band this afternoon.
Need to read the instructions and download driver and tools before installing. Initial settings with buffer rate at 512 samples give high latency and I/O delay but reduce it down to say 32 or 48 and it's all green.
Need to have mic on input 1 and bass on input 2. Phantom power switched on, HI-Z button for bass input2 'on' (pushed in).
Can only hear my mic and bass thru' headset when I'm in a session or recording - not during audio setup for some reason. Maybe because I have the input/DAW dial turned all the way to DAW as advised by JK.
Can be used on USB2.0 and it's fine so USB3.0 is probably overkill unless you need the higher quality for recording. With USB2.0, instructions say you need an external power source - a separate USB charger connection. Seems to work without, but power supply solely through the USB2.0 may drop out from time to time?
Will update after band session test.
Thanks, Colin - hope the session with your band this afternoon goes well, and we'll look forward to hearing how it goes!
Kevin
Presonus Firestudio doesn't let program start Windows 10, 7 (compatibility)
Presonus Firebox - Too much latency, but will kindof work.
04-27-2020, 03:31 AM
(This post was last modified: 04-27-2020, 03:34 AM by Guyfi.)
I am using a RME Fireface 800 (FireWire via express card) with an old HP Probook 4530s (Windows 10) at 5.9ms latency. Also using an ESI UGM96 on the same laptop (Usb 2.0) at 4.4ms latency. Both have been stable enough to jam with guys in my city and halfway across the country.
Myucka - thanks for the info! I’ve updated the list. Hope you can get the latency down on your Firebox.
DeadNZ - thanks for the info! I’ve updated the list, and hope you’re able to get your FireStudio Mobile work.
Guyfi - thanks for the info! I’ll add the info fo the Fireface 800 and move the UGM96 to the “Working” category.
Kevin