• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Add Audio Track Does Nothing
#7
Thanks I'll give it a shot.  I'm using a windows  machine,  but hopefully I can find the interface's sample rate.  I appreciate your response.

Scott

(04-04-2020, 02:32 AM)Scott_Graham Wrote: Thanks I'll give it a shot.  I'm using a windows  machine,  but hopefully I can find the interface's sample rate.  I appreciate your response.

Scott


No luck on my end - I hope your solution works for standupbassist. 

I did find the sample rate for the recording portion of my audio interface in windows under the advanced options within its properties page under control panel.  I ended up changing the sample rate of the recording portion of the interface via the windows control panel from 44.1 to 48 kHz, as Jamkazam was complaining about the speaker output sample rate being 48 kHz, while the recording side was set to 44.1 kHz.  However, in all cases, I'm still at the configure page without available tracks.

Scott
  Reply


Messages In This Thread
Add Audio Track Does Nothing - by standupbassist - 04-02-2020, 11:03 PM
RE: Add Audio Track Does Nothing - by cstats - 04-04-2020, 01:45 AM
RE: Add Audio Track Does Nothing - by cstats - 04-06-2020, 12:35 AM
RE: Add Audio Track Does Nothing - by vanselus - 04-14-2020, 04:57 AM
RE: Add Audio Track Does Nothing - by Scott_Graham - 04-04-2020, 02:32 AM
RE: Add Audio Track Does Nothing - by cstats - 04-04-2020, 03:27 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)