Do you hear distortion in your headphones that is not heard by session partner?
Never
0%
0
Rarely
20.00%
1
Sometimes
60.00%
3
Always
20.00%
1
5 vote(s)
* You voted for this item. [Show Results]

  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Headphone distortion
#1
I have searched the forum for "headphone distortion" and found no posts.
I have also searched for "headphone" and I don't see any posts that deal with headphone distortion.
Apologies in advance if this topic has been covered.  If so, please point me to the discussion.

Any help would be valuable, as JK is basically unusable for me until I beat the following challenge:

The Problem
With my headphones on, I'm getting distortion that sounds (when I sing) as if I had plastic wrap over my mouth.
I also get distortion when I play my acoustic guitar and I do not sing.
Both of these occur when I'm using a microphone to pick up my singing or playing.
I also get distortion when I play my digital piano directly (1/4" jack) into my interface, and don't use the microphone.
The distortion is worse when I play or sing more loudly.

Other participants claim they do not hear this distortion; it is local only to my setup.

When there are no other participants (I am in a private solo session) and I record myself in session using the JK "Record" feature,
my recording lacks the distortion (it may be that it is present, but is lower in volume, relative to the signal) I heard when making the recording.

I get no headphone distortion with the same headphones when using the exact same setup recording into my DAW (Cakewalk/Bandlab).
I get no headphone distortion any other time I used the headphones, including listening to Youtube videos, etc.

Info that may be relevant
My Steinberg audio interface has a red LED that shows when the signal is too hot, and that LED is not lighting (I have verified the LED is not broken).
I am also getting complete dropouts occasionally, when I cannot hear either myself or the other participants for about 1-2 seconds.
This dropout problem is less painful than the headphone distortion.
I just made an adjustment to my computer configuration so that the Service Host SysMain process is disabled, because it causes occasional heavy temporary
CPU usage which may have caused the dropouts.  Too soon to tell if that helps.

I have only one audio input configured.
I have played with the volume levels in the "audio inputs" and "personal mix".
Currently, the level of the slider in "audio inputs" is at the top of the green.
The level of the other slider, "personal mix" is just under the third bar from the top.
During the performance I don't see either of the dynamic level meters go into the red.

Groove Tube PSM1 microphone
Beyer Dynamic DT 770 Pro headphones
Steinberg UR22 mkII audio interface using native ASIO driver

Windows 10 computer (HP)
The following info comes from Control Panel->System
dual-core AMD A10-5700 APU
8 GB RAM
64-bit operating system

Windows power management is configured to use "High-performance" instead of "Balanced",
  and maximum and min processor state are both set to 100%, (as is recommended by other posts in this forum, and resources on JK)

Any help or advice is appreciated!
Edward
  Reply


Messages In This Thread
Headphone distortion - by edward.allen@yahoo.com - 02-16-2021, 07:09 PM
RE: Headphone distortion - by GDJ - 02-16-2021, 11:47 PM
RE: Headphone distortion - by Zlartibartfast - 02-17-2021, 03:32 AM
RE: Headphone distortion - by GDJ - 02-17-2021, 04:06 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)