• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Setup to connect musician
#2
(10-04-2020, 11:40 AM)Ringo Scheithauer Wrote: Hello,

does someone now how you can connect a musician if the rest of the band is sitting all together in on rehearsal room.
The setup is the following:

all musicians in the rehearsal room connect to a mixing desk. Stereo track of mixing desk goes to interface. Interface is connected with JK. Other musician is connected with his gear to JK. The rehearsal room does not hear the musician. Does someone know how the routing of the mixing desk should be set up?

It sounds like an easy problem but we are struggling now for quite a while...
>>>
You'll somehow need to get the return signal from Jamkazam to the musicians in the "rehearsal room". Depending on your audio interface and your mixer's capabilities this is done in different ways.
Most practical would be to route the Jamkazam return signal to a (stereo?) aux pair and into your local (headphone)amplification.
  Reply


Messages In This Thread
Setup to connect musician - by Ringo Scheithauer - 10-04-2020, 11:40 AM
RE: Setup to connect musician - by Dimitri Muskens - 10-04-2020, 04:03 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)