• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
latency suddenly went from 5 to 7.5
#12
I'm getting confused between sample rate and buffer size.

In Focusrite Control, I can set the sample rate.
In the Focusrite ASIO panel (not part of the Focusrite Control application), I can set sample rate and buffer size.
In JK, in gear setup, I can set the sample rate, or I can select "Match". I've been selecting "Match", but perhaps I should specify?

It seems that no matter what I do, JK will reset Focusrite's buffer size. Sometimes it will also change the FR sample rate. 

What is the optimal combination of sample rate and buffer size? I thought that I previously had 48k/48, but perhaps not.

I'm probably being dense, but can you explain, step-by-step, what you think I should do?
  Reply


Messages In This Thread
RE: latency suddenly went from 5 to 7.5 - by maxinegerb - 09-12-2020, 09:03 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)