• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Plug ins not working?
#1
Hi:  My set up is as follows:

I plug my guitar into Channel 2 of my audio interface. I have thus selected Channel 2 as my Input on JamKazam and Outputs 1 and 2 of my interface, as my Outputs.

I also elected by Bias 2 guitar amp simulator, as my plug in. It all was accepted. However, when I record audio of my session, I only hear the non processed sound of my guitar. Why is it that I do not hear the processed sound? The plug in is active, but all i hear is the clean sound of my guitar. I am concerned because I suspect the prople I jam with are probably only hearing the clean sound of my guitar as well. How do i JamKazam to recognize the post plug in processed sound?


Thank-you!
  Reply
#2
(11-05-2020, 09:11 PM)Francis Wrote: Hi:  My set up is as follows:

I plug my guitar into Channel 2 of my audio interface. I have thus selected Channel 2 as my Input on JamKazam and Outputs 1 and 2 of my interface, as my Outputs.

I also elected by Bias 2 guitar amp simulator, as my plug in. It all was accepted. However, when I record audio of my session, I only hear the non processed sound of my guitar. Why is it that I do not hear the processed sound? The plug in is active, but all i hear is the clean sound of my guitar. I am concerned because I suspect the prople I jam with are probably only hearing the clean sound of my guitar as well. How do i JamKazam to recognize the post plug in processed sound?


Thank-you!

>>>
Only 32bit plugins are supported. Could that be your issues? (using 64bit?)
  Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)